Installation Guide

1. Marking and Drilling Track Holes
• Hold up your Track so that
the marked line from the
previous step is visible
through the Track holes.
• Mark an intersecting line in
the center point of each of
the Track holes.
• Set the Track down.
• Using a drill with 1/4” drill
bit, drill out your marked
Track holes.*
*Be sure you are drilling into
wall studs. If your track holes
are not lining up with your
studs, you will need to install
your Track onto a header. The
header needs be attached to
your wall through the studs.
This will provide the stability
your wall needs to hold the
weight of your Door.
1/4”
2. Hanging Your Track
• e end holes will be
installed with a either a Hard
Stop or a Lag Soft Stop.
• In this order: Adjustable Spacer,
Flat Track, [Hard or Lag Soft]
Stop, 1” Washer, and Lag Screw.
Using a ratchet with a 9/16”
socket, tighten the Lag Screw
most of the way, enough to hold
the Track in place, but allowing
the Track to move.
• Swing the Track up to be
horizontal, and repeat the same
step on the opposite end of the
Track.
• e hardware for the middle holes will
be installed in this order: Adjustable
Spacer, Flat Track, 1” Washer, and Lag
Screw. Using a ratchet with a 9/16” socket,
tighten the Lag Screw most of the way.
• Repeat on all remaining middle Track
holes.
• After all Lag Screws are in, fully tighten
all using your ratchet with socket, being
careful not to over-tighten to avoid
stripping the wall studs.
9/16”
Hard Stop or Lag Soft Stop
• Loosely attach one end of the Track
using a Spacer and a Hard Stop or a
Lag Soft Stop (see below).
• Swing the Track up and loosely
attach the other end, using a Spacer
and a Hard Stop or a Lag Soft
Stop (see below).
• e center holes can now be loosely
attached (see below).
9/16”
3. Hole Installation
Installing the Track
Page 12