How to Guide

TECHNICAL DATA
V2300 SYSTEM INVERTED MARKING PAINT
Rust-Oleum Corporation Form: GDH-1092
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 032416
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
PHYSICAL PROPERTIES .
INVERTED MARKING PAINT
Resin Type
Vinyl Toluene Modified Alkyd
Pigment Type
Varies
Solvents
Acetone, Toluene, Xylene
Solids
By Weight
17-23%
By Volume
—
MIR
Maximum Value of 1.2
Fill Weight
15 oz. (426 g)
Recommended Dry Film
Thickness (DFT) Per Coat
1-2 mils
(25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
300-350 lineal feet (91-106 meters) @ 1.5" wide stripe
Coverage is dependent on surface porosity
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
<5 minutes
Handle
NA
Recoat
NA
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.