Use and Care Manual

TECHNICAL DATA

V2100 SYSTEM ENAMEL AEROSOL

Form: GDH-682

Rev.: 052317

.PRODUCT APPLICATION (cont.) .

SURFACE PREPARATION (continued)

GALVANIZED STEEL: New galvanized steel may contain a

surface wax or oil from the fabricator. This must be removed with

Krud Kutter Orignal

Cleaner/Degreaser, commercial detergent or

other suitable cleaner. NOTE: Only the V2100 System

Galvanizing Compounds are to be used on galvanized steel. Do

not use any other of the V2100 System Primers or Finish Colors.

WEATHERED GALVANIZED STEEL: Remove loose rust and

stains by hand tool (SSPC-SP-2) or power tool (SSPC-SP-3)

prior to application of the Cold Galvanizing Compound.

.PRODUCT APPLICATION (cont.) .

APPLICATION

Use when temperature is above 50°F (10°C) and humidity is

below 85% to ensure proper drying. Surface temperature must

be between 50-100°F (10-38°C).

Use primer on bare or rusted surfaces. Do not use any primer

with V2116838 High Temperature Aluminum, V2176838 High

Temperature Black, V2117838 Bright Galvanizing Compound or

V2185838 Cold Galvanizing Compound.

Protect surrounding surfaces from overspray. Overspray can

carry a significant distance. Shake can for one minute after

mixing ball is heard. Hold can 10-14 inches from surface. Apply

several light coats a few minutes apart to avoid drips and runs.

DRY & RECOAT TIMES

Recoat within 1 hour or after 24 hours. allow more time in cooler

temperatures.

CLEAN-UP

Wipe off tip before storing. Clean-up wet paint with xylene or

mineral spirits. Properly discard empty container. Do not burn or

place in trash compactor. Empty container can be recycled.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a solvent

such as mineral spirits. Do not insert any object into can valve

opening.