Technical Specifications

ManualsBrandsRust-Oleum ManualsInterior Paint & StainHigh Performance 9100 System DTM Epoxy Mastic Immersion Activator - 1 gal.

EPOXY

TECHNICAL DATA RO-51

9100 SYSTEM

DTM EPOXY MASTIC

.DESCRIPTION AND USES .

A two-component, high solids epoxy coating for use in

moderate to severe environments. It is specifically designed

for application directly on sound rusted steel with minimum

surface preparation. It can also be used on clean steel,

galvanized metal, concrete (including concrete floors),

previously coated and slightly damp surfaces. It may also be

used for water immersion service, using High Performance

Industrial DTM Epoxy Mastic standard premix bases only with

9102402 Immersion Activator. (Note: Do not use for

immersion service in potable water tanks). High Performance

Industrial DTM Epoxy Mastic can be used indoors or out.

While exposure to sunlight and certain interior lighting

conditions causes fading and chalking of all epoxy type

coatings, these changes are cosmetic in nature only and film

integrity and performance will not be adversely affected.

Epoxy coatings will yellow with age. This is most noticeable

with interior applications of white or light colors which are not

subjected to bleaching from Sunlight. Note: 9102402

Immersion Activator and 9104402 Fast-Cure Activator

produce a semi-gloss finish. Also,using the 9104402 Fast-

Cure Activator may result with a slight colorshift when

compared with products using the 9101402 Standard

Activator.

. .

.COMPANION PRODUCTS .

RECOMMENDED PRIMERS

System is self-priming

COMPATIBLE PRIMERS

Extended Recoat Epoxy Primers (9300 System)

Summary of content (4 pages)

PAGE 1
EPOXY TECHNICAL DATA RO-51 9100 SYSTEM DTM EPOXY MASTIC .DESCRIPTION AND USES .COMPANION PRODUCTS . RECOMMENDED PRIMERS A two-component, high solids epoxy coating for use in moderate to severe environments. It is specifically designed for application directly on sound rusted steel with minimum surface preparation. It can also be used on clean steel, galvanized metal, concrete (including concrete floors), previously coated and slightly damp surfaces.
PAGE 2
TECHNICAL DATA 9100 SYSTEM DTM EPOXY MASTIC .PRODUCT APPLICATION . .PRODUCT APPLICATION (cont.) ALL SURFACES: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with Pure Strength® Cleaner/Degreaser item #3599402 or other suitable cleaner. Rinse with fresh water and allow to dry. STEEL: Hand tool (SSPC-SP-2) or power tool (SSPC-SP-3) clean to remove loose rust, scale, and deteriorated previous coatings to obtain a sound rusted surface.
PAGE 3
TECHNICAL DATA 9100 SYSTEM DTM EPOXY MASTIC PRODUCT APPLICATION (cont.) . PERFORMANCE CHARACTERISTICS EQUIPMENT RECOMMENDATIONS System Tested (Comparable equipment also suitable.) Topcoat: DTM Epoxy Mastic with 9101 Activator BRUSH: Use a good quality natural or synthetic bristle brush. ROLLER: Use a good quality lamb’s wool or synthetic fiber (3/8-1/2"nap). PENCIL HARDNESS METHOD: ASTM D3363 RESULT: B (7 days), 4H (30 days) AIR-ATOMIZED SPRAY: Method Fluid Tip Fluid Delivery Atom.
PAGE 4
TECHNICAL DATA 9100 SYSTEM DTM EPOXY MASTIC . PHYSICAL PROPERTIES . 9101 Activator 9102 Immersion Act. 9103 Low Temp. Act. 9104 Fast-Cure Act.