Technical Specifications

TECHNICAL DATA
SRT-12
STOPS RUST
®
ALUMINUM PRIMER QUART
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-710
Rev.: 091219
PHYSICAL PROPERTIES
ALUMINUM PRIMER
Resin Type
Water-based Acrylic
Pigment Type
Titanium Dioxide
Solvents
Water, Propylene Glycol, Ester Alcohol
Weight
Per Gallon
10.2 lbs.
Per Liter
1.2 kg
Solids
By Weight
51.5%
By Volume
40.4%
Volatile Organic Compounds
<150 g/l (1.14 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
4.0-6.0 mils
(100-150µ)
Practical Coverage
at Recommended DFT
55-90 sq.ft./qt.
(5.0-8.2 m
2
)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1-2 hours
Handle
2-4 hours
Recoat
1-3 hours
Topcoat
Brush on Latex Enamel 1-2 hours
Brush on Oil Based Enamel 1-2 hours
Aerosol 16-24 hours
Shelf Life
5 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.