Technical Specifications

2
Form: CS973
Rev.: 052312
TECHNICAL DA T A
STOPS RUST HAMMERED SPR A YS
PRODUCT APPLICATION (cont.)
P AINTING
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can the
same distance from the surface. Keep the can in motion while
spraying. Apply two or more light coats a few minutes apart to
avoid drips and runs. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% rela tive
humidity. Allow more time at cooler temperatures. Dries to
touch in 15 minutes and fully dry in 24 hours. Recoat within
1 hour or after 48 hours.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.