Manualshelf

Technical Specifications

ManualsBrandsRust-Oleum ManualsSpray Paint7215830
12
TECHNICAL DATA
SRT-05
STOPS RUST
®
HAMMERED SPRAYS
1
DESCRIPTION AND USES
Rust-Oleum
®
Stops Rust
®
Hammered Sprays are designed
to provide a durable protective coating with excellent
resistance to rust, and excellent resistance to abrasion,
fading, chipping, and dulling. These sprays apply easily,
provide excellent coverage and dry fast to a tough attractive
finish. Rust-Oleum Stops Rust Hammered Sprays are ideal
for ferrous, non-ferrous metal and wood surfaces. Not for
use on galvanized metal.
PRODUCTS
SKU
DESCRIPTION (12 Ounce Aerosol)
7210830
Gold Rush
7211830
Deep Green
7212830
Light Blue
7213830
Silver
7214830
Gray
7215830
Black
7216830
Deep Blue
7217830
Bright Red
7218830
Dark Bronze
7219830
Verde Green
210849
Copper
210880
Brown
248072
White
250898
Ivory
300607
Matte Black
314418
Matte Brown
345377
Matte Copper
PRODUCT APPLICATION
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is between 50°-90°F (10°-
32°C) and humidity is below 70% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or galvanized metal. Avoid spraying in very windy,
dusty conditions. Cover surrounding area to protect from
spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or
other suitable cleaning method. Rinse with fresh water and
allow to thoroughly dry. Remove loose paint and rust with a
wire brush or sandpaper. Previously coated surfaces must
be sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile.
PRODUCT APPLICATION (cont.)
SURFACE PREPARATION (cont.)
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRIMING
Use of a Stops Rust
®
Primer provides added corrosion
protection, superior adhesion and hiding and is especially
recommended for bare wood and metal. The following
primers are recommended.
7769830
Rusty Metal Primer
7780830
Clean Metal Primer
2081830
Light Gray Auto Primer
2067830
Red Auto Primer
2089830
Dark Gray Auto Primer
APPLICATION
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN.
Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply 2 or more light coats a few minutes
apart to avoid runs and sags. Do not use near open flame.
DRY AND RECOAT TIMES
Based on 70°F (21°C) 50% relative humidity. Allow more
time at cooler temperatures. Dries to touch in 15 minutes
and is fully dry in 24 hours. Recoat before 1 hour or after 48
hours.
CLEAN UP
Wipe off tip before storing. Clean up wet paint with Xylene
or mineral spirits. Throw away empty can in trash pickup.
Do not burn or place in home trash compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a
solvent such as mineral spirits. Do not stick a pin or other
objects into the stem.

Summary of content (2 pages)