Installation Instructions
6
C. Once the material is thoroughly mixed,
use a scissors to cut a corner off of the
pouch. Then pour the entire contents of
the pouch into an empty bucket making
sure to squeeze the pouch to remove all
the material.
ATTENTION
Add the Color Shot
™
by pouring the ENTIRE
CONTENTS of the container into the mixing
bucket, use a paint stick to scrape the sides
to get all of the tint out. Using a paddle mixer
and a drill, thoroughly mix the tint in for 30-60
seconds. Make sure at some point to scrape
sides of the bucket to ensure all components
and tint are thoroughly mixed together.
Application
ATTENTION:
™
to apply this product. Also, DO NOT
pour material into a roller pan. This product is
not designed to be applied out of a roller pan
Pour the mixed material from the bucket on the
roughly 4’-5’ ribbons. Make sure the ribbon are
at least 2-3” wide.
Using a 3” paint brush, cut the material in
around the perimeter on half the area to
material in 4’ x 4’ sections in an even coat
pattern will provide the most uniform results.
Continue to thoroughly roll this material in
seems to be “see-through” continue to work
the material with the roller until a solid color is
achieved. Pour material as needed to
end of the batch, use a paint stick to remove
creating thick spots while overlapping into
previously coated areas by pouring your new
ribbon of product approx. 2 feet away from the
coated area. Use the roller to pull the material
pouch.
DO NOT pour ribbons of material over control
joints or roll over control joints. Control joints
are not meant to be coated with this material.
ANTI-SLIP:
™
product. Broadcast dry silica sand by grabbing
thumb and throwing it up in the air over the wet
coating as you go.