Installation Instructions
11
be de-linted using duct tape. do not wrap the
tape around the roller, rather wrap the tape
around your hand with the sticky side facing
out and lightly dab into the roller and/or sweep
the surface to remove any loose hairs. This is a
thick nap roller of high quality but should always
be cleaned using this method before use.
ATTENTION
A. Pour the two individually tinted containers
into separate sides of the Color System
each chamber until the colors are almost
aside the mixed material buckets out of the
way until more product is needed in the
roller pan.
B. Cut in the edges by using a 3” chip brush,
dipped in a small amount of each color
simultaneously, to blot along the edges
(Once you start with the roller application,
run the roller lightly along the edge of the
C.
down on the roller as this will cause it to
thicken up and reduce the texture that can
be achieved. Get just enough material on
the roller to fully color each side.
in which color and be consistent, failure to
do this will blend the colors too much. As a
general rule, the metal roller frame should
always be on the right side of the pan when
dipping the roller.
D.
the material out. There should be little to
no pressure applied to the roller during this
step. Once the M and W pattern has been
results, change roller direction continuously
while spreading the material lightly with the
be able to cover about 25 square feet (5’ x
on target to apply the material properly.
unwanted blurring of the two colors. The goal is
Continue this process until the entire area has
been coated, adding more material to the pan
when necessary.
Additional rollers may be required for larger
areas to keep the roller from stiffening up and
a roller will be able to coat 500 sf. If the roller
gets sticky or hard to work with, change it out.
pouch.
not meant to be coated with this material. Use
ANTI-SLIP:
™
product. Broadcast dry Silica Sand by grabbing
thumb and throwing it up in the air over the wet
coating as you go.
Application
Using the 9” Dualie Roller Kit
™