Use and Care Manual

TECHNICAL DATA
ROC-164
RUST-OLEUM
®
PHOTO TRANSFER
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙837∙8677
www.rustoleum.com
Form: ARJ-1845
Rev.: 051619
PHYSICAL PROPERTIES
PHOTO TRANSFER
Resin Type
Copolymer of Vinyl Acetate and Butyl Acrylate
Pigment Type
n/a
Solvents
Water, Glycol
Weight
Per Gallon
8.70 lbs.
Per Liter
1.04 kg
Solids
By Weight
46.0%
By Volume
43.7%
Volatile Organic Compounds
<25 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.0 mils
Wet Film to Achieve DFT
(Unthinned material)
3.5-4.5 mils
Practical Coverage at Recommended
DFT (assume 15% material loss)
21 sq.ft./half pint
Dry Times at 77°F
(25ºC) and 50%
Relative Humidity
Touch
25 minutes
Handle
30 minutes
Recoat
30 minutes
Full Cure
7 days
Shelf Life
2 years
Flash Point
>200°F
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.