How to Guide

TECHNICAL DATA
SRT-01
STOPS RUST
®
ENAMEL SPRAYS
2
Form:
GDH-678
Rev.:
092118
PRODUCT APPLICATION (cont.)
PRIMING
Use of a Stops Rust
®
Primer provides added corrosion
protection, superior adhesion and hiding and is especially
recommended for bare wood and metal. The following
primers are recommended.
7769
Rusty Metal Primer
7780
Clean Metal Primer
2081
Light Gray Auto Primer
2067
Red Auto Primer
2089
Dark Gray Auto Primer
APPLICATION
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN.
Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply 2 or more light coats a few minutes
apart to avoid runs and sags. Do not use near open flame.
DRY AND RECOAT TIMES
Based on 70°F (21°C) 50% relative humidity. Allow more
time at cooler temperatures. Dries tack free in 2-4 hours, to
handle in 5-9 hours and fully dry in 24 hours. Primers may
be top coated immediately. Apply a second coat or clear
coat within 1 hour or after 48 hours.
PRODUCT APPLICATION (cont.)
CLEAN UP
Wipe off tip before storing. Clean up wet paint with Xylene
or mineral spirits. Throw away empty can in trash pickup.
Do not burn or place in home trash compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a
solvent such as mineral spirits. Do not stick a pin or other
objects into the stem.