SDS

Date Printed: 10/10/2022
4. First-Aid Measures
FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical
attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the
lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-Fighting Measures
EXTINGUISHING MEDIA: Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN -7°C (20°F). EXTREMELY FLAMMABLE LIQUID
AND VAPOR!Water spray may be ineffective. Closed containers may explode when exposed to extreme heat due to buildup of
steam. Closed containers may explode when exposed to extreme heat. Vapors may form explosive mixtures with air. Vapors can
travel to a source of ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame. Perforation of the
pressurized container may cause bursting of the can.
SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent pressure buildup and possible
autoignition or explosion. Full protective equipment including self-contained breathing apparatus should be used. Evacuate area and
fight fire from a safe distance. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
Special Fire and Explosion Hazard (Combustible Dust): No Information
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Remove
all sources of ignition, ventilate area and remove with inert absorbent and non-sparking tools. Dispose of according to local, state
(provincial) and federal regulations. Do not incinerate closed containers. Ventilate area, isolate spilled material, and remove with
inert absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Follow all SDS and label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents under
pressure. Do not store above 120°F (49°C). Store large quantities in buildings designed and protected for storage of flammable
aerosols. Keep away from heat, sparks, flame and sources of ignition. Avoid excess heat. Product should be stored in tightly sealed
containers and protected from heat, moisture, and foreign materials.
Advice on Safe Handling of Combustible Dust: No Information
8. Exposure Controls / Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Methyl Ethyl Ketone 78-93-3 30.0 200 ppm 300 ppm 200 ppm N.E.
n-Butyl Acetate 123-86-4 30.0 50 ppm 150 ppm 150 ppm N.E.
Methyl Acetate 79-20-9 25.0 200 ppm 250 ppm 200 ppm N.E.
Liquefied Petroleum Gas 68476-86-8 25.0 N.E. N.E. N.E. N.E.
Titanium Dioxide 13463-67-7 5.0 0.2 mg/m3 N.E. 15 mg/m3 N.E.
Solvent Naphtha, Light Aromatic 64742-95-6 5.0 N.E. N.E. N.E. N.E.
Dimethyl Sulfoxide 67-68-5 1.0 N.E. N.E. N.E. N.E.
3-Aminopropyltriethoxysilane 919-30-2 1.0 N.E. N.E. N.E. N.E.
Carbon Black 1333-86-4 1.0 3 mg/m3 N.E. 3.5 mg/m3 N.E.
N-Methyl 2-Pyrrolidone 872-50-4 1.0 N.E. N.E. N.E. N.E.
bis(1,2,2,6,6-Pentamethyl-4-
Piperidinyl) Sebacate
41556-26-7 1.0 N.E. N.E. N.E. N.E.
No Information
Page 3 / 7