Manualshelf

Technical Specifications

ManualsBrandsRust-Oleum ManualsCaulks & SealantsRust Reform & Seal Automotive Flat Black Rubberized Spray - 12 oz.
12
TECHNICAL DATA
SRT-51
STOPS RUST
®
2-IN-1 RUST REFORM & SEAL
1
DESCRIPTION AND USES
Rust-Oleum
®
Stops Rust 2-IN-1 Rust Reform & Seal is a
flexible, rubberized paint that seals rust and protects metal
surfaces from corrosion and moisture. Its trusted formula
provides a chemical and abrasion resistant barrier from rust
on cars, trucks, trailers and other recreational vehicles.
PRODUCT
SKU
DESCRIPTION (Aerosol)
344713
2 In 1 Rust Reform & Seal
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE
STARTING PROJECT
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is above 50°F (10°C) and
humidity is below 65% to ensure proper drying. Avoid
spraying in very windy, dusty conditions. Cover nearby
objects to protect from overspray.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Apply to bare, primed or rusted metal
surfaces including the underbody and wheel wells.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle DO NOT STRIKE. Contact
Rust-Oleum. Shake often during use. To start, hold can
upright 12-16” from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. While spraying,
keep the can the same distance from the surface and in
motion. Remove any overspray from the auto finish
immediately. For best results, apply 2 coats. Allow coating to
dry 1-2 minutes between coats.
DRY AND RECOAT
Air dry for a minimum of one hour at 70°F (21°C) and 50%
relative humidity before touching. Allow more time at cooler
temperatures. Surface can be re-coated before 2 hours or
after 48 hours.
CLEAN UP
Wipe off tip before storing. Clean up wet paint with Xylene
or mineral spirits. Throw away empty can in trash pickup.
Do not burn or place in home trash compactor.
CLOGGING
After use, turn can upside down and press spray nozzle until
spray is clear to prevent clogging. If valve clogs, twist and
pull off spray tip and rinse it in a solvent such as mineral
spirits. Do not stick a pin or other objects into the stem.

Summary of content (2 pages)