Use and Care Manual

PHYSICAL PROPERTIES
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙683∙5667
www.rustoleum.com
Form: ARJ-1767
Rev.: 022619
TECHNICAL DATA ROC-146
RUST-OLEUM
®
GARAGE + INTERIOR FLOOR PRIMER
GARAGE+ INTERIOR FLOOR PRIMER
Resin Type
Acrylic
Pigment Type
Titanium Dioxide, Carbon Black
Solvents
Water, Propylene Glycol
Weight
Per Gallon
11.2 lbs.
Per Liter
1.34 kg
Solids
By Weight
49.3%
By Volume
28.6%
Volatile Organic Compounds
<100 g/l
Recommended Dry Film Thickness (DFT)
Per Coat
1-2 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
4-7 mils
(100-175µ)
Practical Coverage at
Recommended DFT (per coat)
200-400 sq.ft./gal
Coverage rate can vary depending on the texture and porosity of the concrete
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Top Coat
After a minimum of 6 hours and before 48 hours
Full Traffic
72 hours
Shelf Life
2 years
Safety Information
For additional information, see SDS