TDS
RUST-OLEUM
®
Garage & Interior Floor Primer is easy to use, revolutionary
technology which allows you to coat over a previously coated or sealed concrete floor
without having to scuff, sand, or grind the surface. Transform your worn garage or
basement floor with any Rust-Oleum floor coating (including water and solvent base).
Simply Clean, Prime, & Coat!
READ ALL INSTRUTIONS CAREFULLY BEFORE STARTING PROJECT
WHERE TO USE: For use on previously coated or sealed concrete floors in garages,
carports, basements, laundry rooms, and other interior surfaces. May be applied to bare,
etched concrete. Note: This Garage & Interior Floor Primer is not a suitable replacement
for etching a concrete surface. Proper surface prep is critical for product performance.
LIMITATIONS: Do not use over superhydrophobic sealers or floors contaminated with
tire seal and protectant products. Not recommended for asphalt. Note: Garage & Interior
Floor Primer is a gray color. Clear topcoats are not recommended for use over
Rust-Oleum
®
Garage & Interior Floor Primer.
SURFACE PREPARATION: For a previously painted, coated, stained, or sealed concrete
surface, use a wire brush to remove any loose or peeling paint. Rinse or sweep away
dust and other particles. Clean the entire floor with Rust-Oleum Cleaner & Degreaser.
Sand (60 - 80 grit) or spot etch all exposed concrete surfaces using Rust-Oleum Clean &
Etch. Rinse thoroughly and allow to dry completely.
WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN YOUNG CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect
yourself and your family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
APPLICATION: Garage & Interior Floor Primer is ready to use. Do not dilute. Stir
thoroughly prior to use. Apply when air (ambient) temperature is 50-90 F (10-32 C) and
relative humidity is below 85%. Do not apply if rain is expected within 24 hours.
Use a brush or edger to trim the perimeter and hard-to-reach areas. Use a long handled
roller and a high-quality, 3/8” nap roller cover to apply an even coat onto the surface.
Apply in 4’x4’ sections, and maintain a wet edge while rolling. Do not let product puddle.
Only one coat is recommended.
DRY TIME: Garage & Interior Floor Primer must be allowed to dry a minimum of 6 hours,
but no more than 48 hours, to ensure proper adhesion of topcoat.
CLEAN UP & STORAGE: Wash tools and equipment with warm water and a mild
detergent. Properly dispose of all soiled rags. Store in a cool, dry area and do not let
product freeze.
COVERAGE: Covers up to 400 sq. ft. per gallon on previously sealed, painted, coated, or
smooth concrete floors. Rough or porous surfaces will require more material.
PRECAUTIONS. May cause eye, nose, throat and skin
irritation. Use only with adequate ventilation. Close container
after each use.
CAUTION: KEEP OUT OF REACH OF CHILDREN - DO NOT TAKE
INTERNALLY.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
VOC < 100 g/L
SATISFACTION GUARANTEED: If you are dissatisfied with this product, contact Rust-Oleum
Product Support at 888-855-1774 for a product replacement or refund of the purchase price.
RUST-OLEUM
®
Garage & Interior Floor Primer is easy to use, revolutionary
technology which allows you to coat over a previously coated or sealed concrete floor
without having to scuff, sand, or grind the surface. Transform your worn garage or
basement floor with any Rust-Oleum floor coating (including water and solvent base).
Simply Clean, Prime, & Coat!
READ ALL INSTRUTIONS CAREFULLY BEFORE STARTING PROJECT
WHERE TO USE: For use on previously coated or sealed concrete floors in garages,
carports, basements, laundry rooms, and other interior surfaces. May be applied to bare,
etched concrete. Note: This Garage & Interior Floor Primer is not a suitable replacement
for etching a concrete surface. Proper surface prep is critical for product performance.
LIMITATIONS: Do not use over superhydrophobic sealers or floors contaminated with
tire seal and protectant products. Not recommended for asphalt. Note: Garage & Interior
Floor Primer is a gray color. Clear topcoats are not recommended for use over
Rust-Oleum
®
Garage & Interior Floor Primer.
SURFACE PREPARATION: For a previously painted, coated, stained, or sealed concrete
surface, use a wire brush to remove any loose or peeling paint. Rinse or sweep away
dust and other particles. Clean the entire floor with Rust-Oleum Cleaner & Degreaser.
Sand (60 - 80 grit) or spot etch all exposed concrete surfaces using Rust-Oleum Clean &
Etch. Rinse thoroughly and allow to dry completely.
WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN YOUNG CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect
yourself and your family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
APPLICATION: Garage & Interior Floor Primer is ready to use. Do not dilute. Stir
thoroughly prior to use. Apply when air (ambient) temperature is 50-90 F (10-32 C) and
relative humidity is below 85%. Do not apply if rain is expected within 24 hours.
Use a brush or edger to trim the perimeter and hard-to-reach areas. Use a long handled
roller and a high-quality, 3/8” nap roller cover to apply an even coat onto the surface.
Apply in 4’x4’ sections, and maintain a wet edge while rolling. Do not let product puddle.
Only one coat is recommended.
DRY TIME: Garage & Interior Floor Primer must be allowed to dry a minimum of 6 hours,
but no more than 48 hours, to ensure proper adhesion of topcoat.
CLEAN UP & STORAGE: Wash tools and equipment with warm water and a mild
detergent. Properly dispose of all soiled rags. Store in a cool, dry area and do not let
product freeze.
COVERAGE: Covers up to 400 sq. ft. per gallon on previously sealed, painted, coated, or
smooth concrete floors. Rough or porous surfaces will require more material.
PRECAUTIONS. May cause eye, nose, throat and skin
irritation. Use only with adequate ventilation. Close container
after each use.
CAUTION: KEEP OUT OF REACH OF CHILDREN - DO NOT TAKE
INTERNALLY.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
VOC < 100 g/L
SATISFACTION GUARANTEED: If you are dissatisfied with this product, contact Rust-Oleum
Technical Support at 1-888-NUFLOOR (1-888-683-5667) for a product replacement or refund
of the purchase price.
FLOOR PRIMER
APPLY OVER ANY
GARAGE & INTERIOR
SEALED CONCRETE PREVIOUSLY COATED CONCRETE
1 GAL (128 FL OZ) | GRAY
22_RO GARAGE &
INTERIOR FLOOR
PRIMER
12-12-18
11 Hawthorn Pkwy., Vernon Hills, IL 60061
800-373-6333 rustoleum.com/brandname
Made in USA | Hecho en E.U.A.
©2018 Rust-Oleum Corporation 349953 1218
Powered by
TOPCOAT WITH ANY FLOOR COATING
®
NO PEEL
PROMISE
NO SANDING
NO GRINDING
COVERS UP TO 400 SQ. FT.
ITEM # 338806
0 20066 42565 4
WARNING!
COMBUSTIBLE LIQUID AND VAPOR.
SKIN IRRITANT.
READ OTHER CAUTIONS ON BACK PANEL.
EYE AND
ADVERTENCIA!
LIQUIDO Y VAPOR COMBUSTIBLES.
IRRITANTE DE LOS OJOS Y DE LA PIEL.