Manualshelf

Technical Specifications

ManualsBrandsRust-Oleum ManualsSpray PaintStops Rust Gray Spray Paint (Actual Net Contents: 12)
12
TECHNICAL DATA
SRT-29
STOPS RUST
®
UNIVSERSAL BONDING PRIMER
1
DESCRIPTION AND USES
Rust-Oleum
®
Stops Rust
®
Universal Bonding Primer is a fast
dry, maximum adhesion primer that firmly bonds any topcoat to
difficult-to-paint surfaces, including two part epoxies. It may be
used on interior or exterior surfaces to include galvanized
steel, wrought iron railings, furniture, aluminum flashings, PVC,
porcelain, masonry, glazed brick, metal, wood, fiberglass and
other surfaces.
Stops Rust Universal Bonding Primer features an advanced
spray system that allows you to spray at any angle, even
upside down for those hard to reach areas. A comfort spray tip
with a wider finger pad reduces fatigue caused by continuous
spraying.
PRODUCTS
SKU
DESCRIPTION (Aerosol)
285011
White Bonding Primer
330491
Gray Bonding Primer
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE
STARTING PROJECT
APPLICATION CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 85% to ensure proper drying. Do
not apply to surfaces that, when heated, exceed 200°F
(93°C). Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method to remove dirt. Rinse with fresh
water and let dry. Remove all oil, grease, wax and petroleum
based materials with mineral spirits. Remove loose paint and
rust with a wire brush or sandpaper. Lightly sand glossy
surfaces.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and a
wet mop. Before you start, find out how to protect yourself and
your family by contacting the National Lead Information Hotline
at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
10-16" from surface and spray in a steady back-and-forth
motion, slightly overlapping each stroke. Keep the can the
same distance from the surface and in motion while spraying.
Apply 2 or more light coats a few minutes apart. Do not use
near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 30 minutes and dries to handle in 1 hour.
Apply a second coat or topcoat at anytime. For two part
epoxies, wait two hours before topcoating.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.

Summary of content (2 pages)