How to Guide

TECHNICAL DATA
ZINSSER
®
ODOR KILLING PRIMER
Rust-Oleum Corporation Form: GDH-1072
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 060217
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties BRUSH GOODS AEROSOL
Resin Type
Styrene Copolymer Shellac
Pigment Type
Talc None
Solvents
Glycol Ethers and Water Acetone, Ethanol, Isopropanol
MIR
NA 1.00 Max
Fill Weight
NA 12 ounces
Weight
Per Gallon
9.1 lbs. NA
Per Liter
1.09 kg NA
Solids
By Weight
42.4% NA
By Volume
37.2% NA
Volatile Organic Compounds
<100 g/l (0.83 lbs./gal.) NA
Recommended Dry Film Thickness
(DFT) per Coat
1.0-1.5 mils
(25-37.5µ)
NA
Wet Film to Achieve DFT (Unthinned
material)
2.5-4.0 mils
(62.5-100µ)
NA
Practical Coverage at Recommended
DFT (assume 15% material loss)
Approximately 350-400 sq.ft./gal. (8.6-
9.8 m
2
/l) depending on application
method and surface porosity
Approximately 8-10 sq.ft./can (0.74-
0.93 m
2
/can depending on surface
porosity
Specular Gloss
20° Gloss - 3.5-4.5 NA
60° Gloss – 20-25 NA
85° Gloss – 20-25 NA
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
25-30 minutes 30 minutes
Handle
25-30 minutes 1 hour
Recoat
45 minutes 1 hour
Full Cure
7 days 7 days
Shelf Life
5 years 3 years
Flash Point
>200ºF (93ºC) -156ºF (-141ºC)
Storage
Protect from freezing. Store indoors at
40-80°F (4-26°C)
NA
Disposal
See label for proper container disposal
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.