SDS

Date Printed: 10/20/2021
Titanium Dioxide 13463-67-7 10.0 10 mg/m3 N.E. 15 mg/m3 N.E.
Hydrous Magnesium Silicate 14807-96-6 5.0 2 mg/m3 N.E. N.E. N.E.
Aliphatic Hydrocarbon 64742-89-8 5.0 N.E. N.E. N.E. N.E.
1-Methoxy-2-Propyl Acetate 108-65-6 5.0 N.E. N.E. N.E. N.E.
Xylenes (o-, m-, p- Isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Solvent Naphtha, Light Aromatic 64742-95-6 5.0 N.E. N.E. N.E. N.E.
Propylene Glycol Monobutyl
Ether
5131-66-8 5.0 N.E. N.E. N.E. N.E.
Carbon Black 1333-86-4 5.0 3 mg/m3 N.E. 3.5 mg/m3 N.E.
Stoddard Solvent 8052-41-3 1.0 100 ppm N.E. 500 ppm N.E.
Ethylbenzene 100-41-4 1.0 20 ppm N.E. 100 ppm N.E.
n-Heptane 142-82-5 1.0 400 ppm 500 ppm 500 ppm N.E.
Octane 111-65-9 1.0 300 ppm N.E. 500 ppm N.E.
Methyl Ethyl Ketoxime 96-29-7 1.0 10 ppm N.E. N.E. N.E.
Solvent Naphtha, Light Aromatic 64742-95-6 1.0 N.E. N.E. N.E. N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Provide general dilution of local exhaust ventilation in volume and pattern to keep TLV of hazardous
ingredients below acceptable limits. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits. Use explosion-proof ventilation equipment. Prevent build-up of vapors by
opening all doors and windows to achieve cross-ventilation.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with organic
vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to exceed
exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
Engineering Measures for Combustible Dust: No Information
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like N.E.
Odor Threshold:
Specific Gravity:
0.796
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Slight
Partition Coefficient, n-octanol/
water:
N.D.
Decomposition Temp., °C:
N.D.
Boiling Range, °C:
47.8 - 5,432
Explosive Limits, vol%:
0.6 - 27.0
Flammability:
Supports Combustion -96
Flash Point, °C:
Evaporation Rate:
Slower than Ether
Auto-Ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
Conditions to Avoid: Avoid temperatures above 120°F (49°C). Avoid all possible sources of ignition.
Incompatibility: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
Hazardous Decomposition: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it emits acrid
smoke and irritating fumes. Contains solvents which may form carbon monoxide, carbon dioxide, and formaldehyde.
Hazardous Polymerization: Will not occur under normal conditions.
Stability: This product is stable under normal storage conditions.
11. Toxicological Information
EFFECTS OF OVEREXPOSURE - EYE CONTACT: Causes Serious Eye Irritation
EFFECTS OF OVEREXPOSURE - SKIN CONTACT: No Information
Rust-Oleum Chalked Ultra Matte Spray
Page 4 / 7