How to Guide

TECHNICAL DATA
UNI-11
UNIVERSAL
®
CLEAR FINISH SPRAYS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-1061
Rev.: 062118
PHYSICAL PROPERTIES
DEAD FLAT CLEAR
HAMMERED
CLEAR
FROSTED
PEARL CLEAR
HIGH GLOSS
CLEAR
Resin Type
Proprietary Acrylic
Pigment Type
Polyethylene,
Polypropylene
Fumed Silica
Polyethylene
N/A
Solvents
Acetone, n-Butane, n-Butyl
Acetate, Propylene Glycol
Monomethyl Ether Acetate,
Xylene, Glycol Ether PnB
Acetone, Ethyl Acetate, n-
Butane, n-Butyl Acetate,
Xylene
Acetone, n-Butane, n-
Butyl Acetate, Propylene
Glycol Monomethyl Ether
Acetate, Xylene, 3-
Ethoxypropionate
Mineral Spirits, Dimethyl
Carbonate, Acetone,
Naphtha
MIR
0.85 Max
Fill Weight
11 ounces
Recommended Dry Film
Thickness (DFT) per Coat
1.0-2.0 mils
(25-50μ)
1.0-2.0 mils
(25-50μ)
0.5-1.0 mils
(12.5-25μ)
1.0-2.0 mils
(25-50μ)
Practical Coverage at Recommended
DFT (assume 15% material loss)
6-8 sq.ft./can
5-7 sq.ft./can
6-10 sq.ft./can
7-10.5 sq.ft./can
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
30 minutes
Handle
1 hour
Recoat
Anytime but wait 5 minutes between coats
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-141°F (-96°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.