SDS

Date Printed: 7/9/2021
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Remove all sources of ignition, ventilate area and remove with
inert absorbent and non-sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not incinerate
closed containers.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Follow all SDS and label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Avoid excess heat.
Store in a dry, well ventilated place. Keep container tightly closed when not in use.
Advice on Safe Handling of Combustible Dust: No Information
8. Exposure Controls / Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Stoddard Solvent 8052-41-3 45.0 100 ppm N.E. 500 ppm N.E.
Aluminum Flake 7429-90-5 15.0 1 mg/m3 N.E. 15 mg/m3 N.E.
Perlite 93763-70-3 10.0 N.E. N.E. N.E. N.E.
Microcrystalline Cellulose 9004-34-6 5.0 10 mg/m3 N.E. 15 mg/m3 N.E.
n-Nonane 111-84-2 5.0 200 ppm N.E. N.E. N.E.
Amorphous Silica 7631-86-9 5.0 N.E. N.E. 50 µg/m3 N.E.
Mica 12001-26-2 5.0 3 mg/m3 N.E. N.E. N.E.
Fumed Silica 69012-64-2 5.0 N.E. N.E. N.E. N.E.
1,2,4-Trimethylbenzene 95-63-6 1.0 N.E. N.E. N.E. N.E.
Trimethylbenzene 25551-13-7 1.0 25 ppm N.E. N.E. N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
Engineering Measures for Combustible Dust: No Information
9. Physical and Chemical Properties
Appearance:
Liquid
Physical State:
Liquid
Odor:
Solvent Like N.E.
Odor Threshold:
Specific Gravity:
0.869
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Negligible
Partition Coefficient, n-octanol/
water:
N.D.
Decomposition Temp., °C:
N.D.
Boiling Range, °C:
116.0 - 4,473
Explosive Limits, vol%:
0.8 - 6.6
Flammability:
Supports Combustion 41
Flash Point, °C:
Evaporation Rate:
Slower than Ether
Auto-Ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
Conditions to Avoid: Flammable hydrogen gas will evolve when product comes in contact with water or damp air. Heat will be
generated. The amount of heat generated will depend upon the volume of material in contact.
No Information
Page 3 / 5