Use and Care Manual

TECHNICAL DATA
WET LOOK CONCRETE & MASONRY LACQUER
Rust-Oleum Corporation Form: GDH-989
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 111915
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Resin Type
Acrylic
Pigment
None
Solvent
Acetone, Parachlorobenzotrifluoride, Xylene
Weight
Per Gallon
7.3 lbs.
Per Liter
0.90 kg
Solids
By Weight
20.1%
By Volume
17.5%
Volatile Organic Compounds
<400 g/l (3.3 lbs./gal.)
Practical Coverage
at Recommended DFT
200 sq.ft./gal. (single coat)
Actual coverage will vary depending on the porosity of the surface
Dry Times @ 70-80º F
(21-27°C) and 50%
Relative Humidity
Touch
30 minutes
Recoat
1-2 hours
Foot Traffic
2 hours
Full Cure
72 hours
Shelf Life
3 years
Flash Point
-4°F (-20°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.