How to Guide

TECHNICAL DATA INS-07
INSPIRE
LACQUER SPRAY
Form: GDH-1308
Rev.: 022817
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Inspire Lacquer is a high luster coating that
provides an ultra smooth and durable finish on wood,
metal and more. Inspire Lacquer is ideal for use on
furniture, lamps, picture frames and other home accents.
.PRODUCTS
SKU (11 ounces) DESCRIPTION
297068 Gloss White Lacquer
297030 Gloss Black Lacquer
297029 Gloss Clear Lacquer
PRODUCT APPLICATION .
READ ALL DIRECTIONS BEFORE BEGINNING
PROJECT
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F (10°C)
and 90ºF (32ºC) and humidity is below 85% to ensure
proper drying. Do not apply to surfaces, when heated,
exceed 200°F (93°C). Do not apply to galvanized steel.
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent or other suitable cleaning method. Rinse
thoroughly with fresh water and allow to thoroughly dry.
Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces to create a
surface profile.
PRODUCT APPLICATION .
WARNING! If you scrape, sand or remove old paint from
any surface, you may release lead paint dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the National Lead Information Hotline at 1-800-
424-LEAD or log on to www.epa.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-12" from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply 2 or more
light coats a few minutes apart. Do not use near open
flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. May
recoat anytime. Dries to touch in 20 minutes, to handle in
30 minutes and is fully dry in 24 hours. Add additional dry
time for multiple coats.
CLEAN-UP
When finished spraying, clear spray valve by turning the
can upside down and pushing the spray button for 5
seconds. Clean-up wet paint with xylene or mineral spirits.
Properly discard empty container. Do not burn or place in
home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not stick pin or other
objects into the stem.