How to Guide

TECHNICAL DATA
SRT-01
STOPS RUST
®
ENAMEL SPRAYS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-678
Rev.: 022819
PHYSICAL PROPERTIES
ENAMEL SPRAY FINISHES
Resin Type
Oil modified Alkyd
Pigment Type
Varies with color
Solvents
Acetone, N-Butyl Acetate, Aromatic Hydrocarbons
MIR
0.95 Max
Fill Weight
12 ounces
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
6-10 sq.ft./can
(0.6-0.9 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
2-4 hours
Handle
5-9 hours
Recoat
Before 1 hour or after 48 hours
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
156°F (69°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.