Manualshelf

Technical Specifications

ManualsBrandsRust-Oleum ManualsConcrete & Blacktop SealersRockSolid® Heavy Duty Concrete Cleaner - 1 gal.
12
TECHNICAL DATA RSD-19
ROCKSOLID
®
HEAVY DUTY CLEANER
Form: GDH-912
Rev.: 120617
1
.DESCRIPTION AND USES .
RockSolid
®
Heavy Duty Cleaner is formulated to clean
grease and oil stains on concrete, brick and masonry. It
also prepares surfaces for finishing by promoting adhesion
when staining, sealing or coating. RockSolid Heavy Duty
Cleaner is suitable for interior and exterior use and is safe
to use near grass and plants.
RockSolid Heavy Duty Cleaner is suitable for use on
garage floors, basements, driveways, carports, patios,
walkways and pool decks prior to staining, sealing or
coating. It can be used on freshly poured concrete.
.PRODUCTS .
SKU Container Size
293422 1-Gallon Heavy Duty Cleaner
PRODUCT FEATURES .
Removes oil, grease, tire marks, dirt and stains
Cleans surface prior to sealing
Designed for use on concrete and masonry
PRODUCT APPLICATION .
READ ALL INSTRUCTIONS CAREFULLY BEFORE
STARTING PROJECT
SURFACE PREPARATION
Proper surface preparation is critical to achieve best
results. Wipe up excess oil and grease spots. Scrape and
sweep away dirt and loose contaminants on the surface.
.PRODUCT APPLICATION (cont.) .
APPLICATION
RockSolid Heavy Duty Cleaner is ready to use. Do not thin.
Use only when air (ambient) temperature is between 50-
90°F (10-32°C) and the relative humidity is below 85%.
Dampen the surface with water. Apply RockSolid Heavy
Duty Cleaner to the entire floor and allow it to soak into the
surface for 5-10 minutes, misting the surface as needed to
keep it damp. Work the product into the surface with a stiff
bristle brush or broom.
Rinse the surface thoroughly with water or power wash to
remove all cleaner residue. Note: If cleaner dries before
rinsing, apply more cleaner and then scrub and rinse. Use
a squeegee or broom to remove excess water from the
surface. A wet/dry shop vacuum can be used. Repeat the
application as needed for hard-to-remove stains.
COVERAGE
Each gallon will cover 200 square feet per gallon.
DRY TIME
Dry time is based on 70°F and 50% relative humidity.
Allow to dry for 24 hours before staining, sealing or
coating.
CLEAN-UP
Wash tools and equipment with soap and warm water.
Properly dispose of all soiled rags and protect unused
product from freezing.
DANGER: CAUSES BURNS TO EYES, SKIN AND IS A
RESPIRATORY IRRITANT. HARMFUL IF SWALLOWED.
KEEP OUT OF REACH OF CHILDREN.

Summary of content (2 pages)