Use and Care Manual

TECHNICAL DATA
CHD-03
RUST-OLUEM
®
CHALKED
CLEAR PROTECTIVE TOPCOAT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙481∙4785
www.rustoleum.com
Form: GDH-774
Rev.: 031622
PHYSICAL PROPERTIES
CHALKED CLEAR PROTECTIVE TOPCOAT
Resin Type
Acrylic Urethane
Pigment Type
NA
Solvents
Water, Glycol Ethers
Weight
Per Gallon
8.5 lbs.
Per Liter
1.02 kg
Solids
By Weight
30.5%
By Volume
28.8%
Volatile Organic Compounds
<250 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.0-2.0 mils
25-50µ
Wet Film to Achieve DFT
(Unthinned material)
4.0-6.0 mils
(100-150µ)
Practical Coverage at Recommended
DFT (assume 15% material loss)
110-150 sq.ft./qt.
(9.7-13.2 m
2
/l)
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
30 minutes
Handle
1-2 hour
Recoat
2hour
Shelf Life
3 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.