How to Guide

ManualsBrandsRust-Oleum ManualsExterior Stains & Floor CoatingsRockSolid 2-part Cherry High-gloss Polycuramine Garage floor polycuramine (Actual Net Contents: 70 -fl oz)

TECHNICAL DATA

ROCKSOLID

METALLIC GARAGE FLOOR COATING

Form: GDH-605

Rev.: 040517

.PRODUCT APPLICATION (cont.) .

SURFACE PREPARATION (cont.)

If the previous coating is well adhered, de-gloss the

surface using 40-80 grit sandpaper, vacuum the surface

and wipe down using urethane grade MEK prior to

application.

MIXING

Both components and environment should be pre-

conditioned to a minimum of 40ºF (4ºC) prior to use. Be

sure the air and surface temperatures are at least 5º

above the dew point. Place a tarp on the ground and

thoroughly mix the material in the pouch by shaking it both

up and down and back and forth and squeezing each side

of the pouch. Any clumps need to be massaged to break

them up to ensure proper blending.

Combine the two components by placing the pouch on the

ground and rolling it from the part A side towards the part

B side like a tube of toothpaste. This will create pressure

in the part A side and force the middle seal to burst,

allowing the two components to mix together. Thoroughly

mix the materials by shaking the pouch back and forth and

squeezing the edges and corners toward the center of the

pouch. Mix for 2-3 minutes. Mix only one pouch at a time.

APPLICATION

Apply only when air, material and floor temperatures are

between 40-90°F (4-32°C). Optimal installation

temperature is 55-90°F (13-32°C). Extreme cold

application temperatures may slow the cure time. Do not

apply in direct sunlight. Do not coat the floor if it is

raining or if extremely damp conditions exist. The concrete

surface must be completely dry at the time of the

application to achieve proper adhesion.

Once the material is thoroughly mixed, use scissors to cut

a corner off of the pouch and pour contents into mixing

bucket. Add the metallic tint (included) to bucket. Mix with

paddle mixer and drill for 3-5 minutes. Pour the mixed

material from the bucket directly onto the floor about a foot

from the back corner wall in 4” wide ribbons, about 5’ long.

Trim the edges from the poured ribbon of material using a

good quality synthetic brush. Roll out the material in 5x5

foot sections for a desired spread rate of 100-125 square

feet. Once a strip across the entire back wall has been

coated, use the roller to put circular patterns in the coating

(like applying wax to a car) to ensure there are not bare

spots, and will give the coating an opaque appearance

once dry. Repeat mixing and application process for each

additional pouch.

THINNING

None required

CLEAN-UP

Use acetone to clean tools and equipment before the

product cures.

.PRODUCT APPLICATION (cont.) .

LIMITATIONS

This product must be installed at the specified spread

rates to perform as described. Do not apply in direct

sunlight. Do not apply product when the substrate and

ambient temperatures are steadily below 40°F (4°C).

SHELF LIFE and STORAGE

Twenty-four (24) months in factory delivered unopened

pouches. Keep away from extreme heat, cold and

moisture. Maintain at a proper storage temperature of 45-

90°F. Keep out of direct sunlight and away from fire

hazards.

.PERFORMANCE CHARACTERISTICS .

Flexibility, ⅛” Mandrel (ASTM D1737) Pass

Hardness, Shore D (ASTM D2240) 90

Gloss (ASTM D523) @ 60° >95

Abrasion Resistance (ASTM D4060)

CS-17 Wheel, 1,000 g load, 1,000 cycles 40 mg