Installation Instructions

TECHNICAL DATA
PEEL STOP –
MIRROR EFFECT
Rust-Oleum Corporation Form: GDH-101
11 Hawthorn Parkway Phone: [phone] Rev.: 072315
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
MIRROR EFFECT
Resin Type
Cellulose Ester
Pigment Type
NA
Solvents
Acetone, N-Butyl Acetate
MIR
2.70 Max
Fill Weight
6 ounces
Wet Film to Achieve DFT
2-5 light wet coats
Practical Coverage at Recommended
DFT (assumes 15% material loss)
3-5 sq.ft./can
Dry Times at 70-80ºF
(21-27ºC) and 50%
Relative Humidity
Touch
5-10 minutes
Recoat
Anytime
Fully Dry
5-10 minutes
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see SDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and
use of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if
any, will be limited to replacement of defective materials. All technical information is subject to change without notice.