Installation Instructions

TECHNICAL DATA SPC-36
MIRROR EFFECT
Form: GDH-101
Rev.: 072315
1
.DESCRIPTION AND USES .
Mirror Effect is an innovative coating that transforms glass
and acrylic glass into a unique mirror finish. It is ideal for
glass vases, candleholders, framed glass, jars and
tabletops. Apply to the reverse or opposite side of
glass. Interior use only.
.PRODUCTS .
SKU Description
267727 6 oz. Mirror Effect
.PAINTING CONDITIONS .
Use outdoors or in a well ventilated area such as an open
garage. Apply when temperature is between 50-90ºF (10-
32ºC) and humidity is below 85% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or galvanized steel. Avoid spraying in very windy
and dusty conditions. Cover surrounding area to protect
from spray mist.
.SURFACE PREPARATION .
Remove water spots and other imperfections on substrate
to achieve optimal results. Clean glass thoroughly with
glass cleaner or soap and water, using a lint free cloth.
Allow glass to dry completely before painting. Coating will
not hide imperfections on substrate.
.PRODUCT APPLICATION .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Make sure to apply
paint to the reverse side of glass that will be displayed.
Hold can upright 10-12” from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Apply using very thin coats, allowing the paint to
dry for 1 minute between coats. Apply up to 5 coats to
achieve the desired mirror effect. Paint will rapidly change
in appearance and mirror effect will appear while coating
dries. The painted side will appear dull with the reverse
side showing the mirror finish. Do not use near open
flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Dries completely in 5-10 minutes. May be
recoated at any time. For added protection, apply a thin
coat of Rust-Oleum Matte Clear (267028) or Stops Rust
®
7776830 Flat Black to the painted side.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.