Technical Specifications

TECHNICAL DATA
STOPS RUST ENAMEL SPRAYS
..PRODUCT APPLICATION (cont.)
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold c an
10-16" from the surface and spray in a steady back-and-f orth
motion, slightly overlapping each stroke. Keep the can the
same distance from the surface. Keep the can in motion while
spraying. Apply 2 or more light coats a few minutes apart to
avoid runs and sags. Metallic Sprays are not recommended
f or outdoor use. Do not use near open flame.
DRY AND RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow mor e time at cooler temperatures. Dries to
touch in 15 minutes, to handle in 30 minut es and fully dry in
24 hours. Apply a second coat within 1 hour or after 24 hours.
A clear coat finish is not r ecommended.
CLEAN UP
W ipe off tip before storing. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in home trash compact or.
CLOGGING
If the valve c logs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.
. .