Technical Specifications

TECHNICAL DATA
PEEL STOP –
CLEAR DRY ERASE
Rust-Oleum Corporation Form: GDH-590
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 032515
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
CLEAR DRY ERASE (ACTIVATED)
Resin Type
Polyamine Epoxy Blend
Pigment Type
NA
Solvents
Water, Glycol Ethers
Weight*
Per Gallon
8.8 lbs
Per Liter
1.05 kg
Solids*
By Weight
46.8%
By Volume
44.0%
Volatile Organic Compounds*
45 g/l (0.37 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
2.5-4.5 mils
(62.5-112.5µ)
Theoretical Coverage at
1 mil DFT (25µ)
113 sq.ft./16 ounces activated
Practical Coverage at Recommended
DFT (assumes 15% material loss)
50 sq.ft./16 ounce kit
Mixing Ratio
3:1 Base to Activator by volume (12 ounces of Part B to 4 ounces of Part A)
Induction Period
None
Pot Life
Up to 90 minutes
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
3-4 hours
Recoat
5-6 hours
Full Cure
3 days
Shelf Life
2 years unopened containers
Flash Point
>200°F (93°C)
Safety Information
For additional information, see MSDS
* Activated material
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.