Installation Instructions

4
OTHER SUPPLIES NEEDED
• An additional person to help
• Shop-Vac with squeegee attachment
• Pressure washer to clean oor (Optional)
• 9” Roller Frame with Extension handle
• 9” 3/8” Nap Roller
• 3” Disposable Paint Brushes (2)
• Disposable Rubber Gloves (Nitrile)
• Stiff-bristled broom
• Garden hose with spray nozzle
RockSolid Anti-Slip™ additive is
recommended for non-slip.
ATTENTION
The RockSolid Polycuramine Clear Top Coat™
will provide extra protection in areas of heavy
use or high trafc. Each Polycuramine Clear
Top Coat™ pouch will cover approx. 250
sq. ft. over a sealed surface. If this product
is being used for a clear coat directly over
concrete the spread rate will vary due to
the porosity of the concrete. 200 sf is the
recommended spread rate per kit.
ATTENTION: Each Polycuramine Clear Top
Coat™ pouch will have a 1 hour pot life.
• Blue Masking Tape (2”)
• Safety Equipment for Etching
• Protective Plastic Sheeting (Tarp or Poly)
• Protective Safety Glasses
• Respirator (NIOSH Approved Respirator
(Optional). Refer to safety/MSDS
information)
• RockSolid Anti-Slip (Optional)
• Plastic Watering Can
That means you have 1 hour to apply this
product to the concrete. Pot life will vary
due to temperature. As temperatures rise
above 80 degrees pot life will be shortened.
Temperature Pot Life
40-80° F 1 hour
81-90° F 45 minutes
A. Place tarp on the ground and thoroughly
mix the material in the pouch by shaking
it (both up and down and back and forth)
and squeezing each side of the pouch. Any
clumps need to be massaged to break them
up and blend them in with the rest of the
COVERAGE: The porosity of the concrete
being coated and the application technique will
affect coverage rate. This RockSolid Floors Kit
provides the materials generally required to
cover 250 sq. ft. of concrete. Application of this
material to stairs, vertical surfaces or to wood
will have reduced coverage rates.
coating. Do this to all pouches so that they
are ready when you need them.
B. Combine the two components by placing the
pouch on the ground and rolling it from the
Part A side towards the Part B side like a
tube of toothpaste. This will create pressure
in the Part A side and force the middle seal
to burst, allowing the two components to
mix together. Thoroughly mix the materials
by shaking the pouch back and forth and
squeezing the edges and corners towards
the center of the pouch. Mixing should be
done for at least one (1) minute. At this point
the product is activated and must be used
within 1 hour.
RockSolid Polycuramine™ Clear Top Coat
®
Installation
Mixing Instructions