SDS

Date Printed: 9/19/2016
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Follow all MSDS/label precautions even after container is emptied because it may retain product
residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents under
pressure. Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of NFPA Class I
flammable liquids. Product should be stored in tightly sealed containers and protected from heat, moisture, and foreign materials.
Store in a dry, well ventilated place. Keep container tightly closed when not in use. Keep away from heat, sparks, flame and sources
of ignition. Avoid excess heat.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Propane 74-98-6 20.0 N.E. N.E. 1000 ppm N.E.
n-Butyl Acetate 123-86-4 10.0 50 ppm 150 ppm 150 ppm N.E.
n-Butane 106-97-8 10.0 N.E. 1000 ppm N.E. N.E.
Talc (Hydrous Magnesium
Silicate)
14807-96-6 10.0 2 mg/m3 N.E. N.E. N.E.
Naphtha, Petroleum,
Hydrotreated Light
64742-49-0 10.0 N.E. N.E. N.E. N.E.
Iron Oxide 1309-37-1 10.0 5 mg/m3 N.E. 10 mg/m3 N.E.
Hydrotreated Light Distillate 64742-47-8 10.0 N.E. N.E. N.E. N.E.
Dimethyl Carbonate 616-38-6 10.0 N.E. N.E. N.E. N.E.
Xylenes (o-, m-, p- isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Acetone 67-64-1 5.0 250 ppm 500 ppm 1000 ppm N.E.
Ethylbenzene 100-41-4 1.0 20 ppm N.E. 100 ppm N.E.
Crystalline Silica / Quartz 14808-60-7 1.0 0.025 mg/m3 N.E. N.E. N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use explosion-proof ventilation equipment. Provide general dilution of local exhaust ventilation in
volume and pattern to keep TLV of hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors
and windows to achieve cross-ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with organic
vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to exceed
exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like
Odor Threshold:
N.E.
Relative Density:
0.862
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Slight
Partition Coefficient, n-octanol/
water:
N.D.
Decompostion Temp., °C:
N.D.
Boiling Range, °C:
-37 - 537
Explosive Limits, vol%:
0.8 - 13.0
Flammability:
Supports Combustion
Flash Point, °C:
-96
Evaporation Rate:
Faster than Ether
Auto-ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
Page 3 / 6