How to Guide

TECHNICAL DATA
ZINSSER
®
MOLD KILLING PRIMER
Rust-Oleum Corporation Form: GDH-252
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 120616
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
MOLD KILLING PRIMER
Resin Type
Styrene Acrylic
Pigment Type
Calcium Carbonate
Solvents
Water, Ethylene Glycol
Weight
Per Gallon
10.4 lbs.
Per Liter
1.25 kg
Solids
By Weight
50.9%
By Volume
38.9%
Volatile Organic Compounds
<100 g/l
Recommended Dry Film Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT (Unthinned
material)
2.5-5.0 mils
(62.5-125µ)
Theoretical Coverage at 1 mil DFT (25µ)
624 sq.ft./gal.
(15.4 m
2
/l)
Practical Coverage at Recommended
DFT (assume 15% material loss)
Approximately 400-450 sq.ft./gal. (9.8-11.0 m
2
/l)
depending on application method and surface porosity
Dry Times at 70°F
(21ºC) and 50%
Relative Humidity
Touch
30 minutes
Handle
1 hour
Recoat
1 hour
Full Cure
7 days
Shelf Life
1 year
Flash Point
>200ºF (93ºC)
Storage
Protect from freezing. Store indoors at 40-80°F (4-26°C)
Disposal
See label for proper container disposal
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.