Use and Care Manual

TECHNICAL DATA
STOPS RUST
®
ANTI-SLIP SLIP RESISTANT COATING
Rust-Oleum Corporation Form: GDH-627
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 012315
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
STOPS RUST UNIVERSAL BONDING PRIMER
Resin Type
Proprietary Non-Hazardous Polymer
Pigment Type
Polypropylene
Solvents
Acetone, Ethyl Benzene, N-Butyl Acetate, Xylene
MIR
2.0 Max
Fill Weight
12 ounces
Recommended Dry Film
Thickness (DFT) Per Coat
1.5-2.5 mils (37.5-62.5µ)
Practical Coverage
at Recommended DFT
10-12 sq.ft./can
(0.90-1.09 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
2-4 hours
Recoat
Apply a second coat within 1 hour or after 48 hours
Fully Dry
Allow surfaces to dry for 24 hours before use
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.