Technical Specifications
TECHNICAL DATA SPC-29
SPECIALTY
HIGH HEAT ULTRA
.DESCRIPTION AND USES .
High Heat Ultra is a rust preventive enamel designed to provide
deep
color and
rich sheen
to protect indoor and outdoor high heat
applications. This durable semi-gloss finish retains excellent
gloss
and
color
retention after repeated heating.
High
Heat sprays
withstand
temperatures up to 1200ºF (648ºC). Ideal for the exterior
of
barbeque
grills,
wood
stoves,
radiators,
fire
pits, fireplace
screens,
automotive parts, and
more.
. .
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an
open
garage. Use when temperature is between 50ºF (10ºC)
and
90ºF (32ºC) and humidity is below 85% to ensure proper
drying. Priming is not
r
ecommended. Do not
us
e on
metal
directly exposed to open flame or in direct contact with
food,
such as a grill grate. Avoid application in very windy and
dusty
conditions. Cover surrounding area to protect from spray
mist.
SURFACE
PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method.
Rins
e with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire brush
or sandpaper. Previously coated surfaces must be sound and
in good condition. Smooth, hard, or glossy finishes should be
scarified by sanding to create a surface profile.
Remov
al of
old paint by sanding,
scr
aping or other means may generate
dust or fumes that contain lead. LEAD IS TOXIC. Contact the
U.S.EPA/Lead Information Hotline at 1-800-424-LEAD or log
on to www.epa.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16” from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the
c
an
the same distance from the surface and x5in motion while
spraying. Apply two or more light coats a few minutes apart to
avoid drips and runs. Do not
us
e near open
flame.
..PRODUCT APPLICATION (cont.) .
DRY & RECOAT
TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow
mor
e time at cooler temperatures. Dries
to
touch in 30 minutes and to handle in 1-2 hours. Allow paint to
dry for 1 hour before heating. Product may emit smoke
and
harmless odor. May recoat within 1 hour or after 48 hours.
CLEAN-UP
Clean valve immediately after use by turning can upside down
and depressing spray button for 3-5 seconds. Clean-up
wet
paint with xylene or
miner
al spirits. Properly discard empty
container. Do not burn or place in home trash
compactor.
CLOGGING
If the valve
c
logs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into
can valve opening.
1
Form:
CS1715
Rev.: 110912