How to Guide

TECHNICAL DATA SPC-29
SPECIALTY
HIGH HEAT ULTRA
Form: GDH-512
Rev.: 092816
1
.DESCRIPTION AND USES .
High Heat Ultra is a rust-preventive enamel designed to provide
deep color and rich sheen to protect indoor and outdoor high
heat applications. This durable semi-gloss finish retains excellent
gloss and color retention after repeated heating. High Heat
sprays withstand temperatures up to 1200ºF (648ºC). Ideal for
the exterior of barbeque grills, wood stoves, radiators, fire pits,
fireplace screens, automotive parts, and more.
.PRODUCTS .
SKU Description
241169 Black
241230 Brown
241232 Aged Copper
270201 Silver
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50ºF (10ºC)
and 90ºF (32ºC) and humidity is below 85% to ensure
proper drying. Priming is not recommended. Do not use on
metal directly exposed to open flame or in direct contact
with food, such as a grill grate. Avoid application in very
windy and dusty conditions. Cover surrounding area to
protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with
fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. Previously
coated surfaces must be sound and in good condition.
Smooth, hard, or glossy finishes should be scarified by
sanding to create a surface profile. Removal of old paint
by sanding, scraping or other means may generate dust or
fumes that contain lead.
WARNING! If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN
DAMGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the U.S.EPA/Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16” from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface
and x5in motion while spraying. Apply two or more light
coats a few minutes apart to avoid drips and runs. Do not
use near open flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 30 minutes and to handle in 1-2 hours. Allow paint
to dry for 1 hour before heating. Product may emit smoke
and harmless odor. May recoat within 1 hour or after 48
hours.
CLEAN-UP
Clean valve immediately after use by turning can upside
down and depressing spray button for 3-5 seconds. Clean-
up wet paint with xylene or mineral spirits. Properly
discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.