Technical Specifications

Form: CS1640

Rev.: 011413

TECHNICAL DATA

ACRYLIC POOL PAINT

.PRODUCT APPLICATION (cont.) .

APPLICATION

Apply only when air and surface temperatures are between

50-90°F (10-38°C) and the relative humidity is less than 85%.

Rust-Oleum Acrylic Pool Paint can be applied by brush, ⅜”

nap roller, or spray. Avoid painting in the midday sun.

Application is recommended early in the day or late in the

afternoon when at least 2 hours of sunlight remain after

completion of the job. Touch-up any bare spots with one coat

of Rust-Oleum Acrylic Pool Paint. For new or bare concrete

and plaster surfaces, apply two coats of Rust-Oleum Acrylic

Pool Paint, and one or two coats of Rust-Oleum Acrylic Pool

Paint to previously painted surfaces at the recommended

coverage rates. In areas of low humidity (less than 20% and

high temperatures over 90°F) dampen the surface to be

painted with a fine mist water spray prior to painting.

Coverage and number of coats will vary depending on

porosity and texture of the surface. The first coat on bare

surfaces can be thinned 10-15% with clean potable (fresh)

water. One gallon covers 175-200 square feet on bare

abrasive blast cleaned or rough surfaces and 350-400 square

feet on recoats. Allow 4 hours drying time to recoat and 3

days before filling outdoor pools, (6 days for indoor pools).

Add 1 extra day of drying for every day of rain prior to filling

the pool.

PERFORMANCE CHARACTERISTICS .

SLIP RESISTANCE SURFACES

The Rust-Oleum Concrete Saver

200 Anti-Skid Additive can

be used on steps, wading and baby pools, and other areas to

improve the slip resistance. Immediately after applying

coating in the desired area, broadcast the 200 Anti-Skid

Additive by hand, to your desired amount, onto the wet film.

After the paint has dried, sweep off loose material and apply

another coat of Rust-Oleum Acrylic Pool Paint to cover and

seal.

CLEAN-UP

When finished, wash tools and equipment with soap and

water. Clean up drips or spatters immediately as dried paint is

very difficult to remove. Properly dispose of all soiled rags.

MAINTENANCE

Recoating of small area touch-up can be made at any time by

following recommended application procedures.