How to Guide

ManualsBrandsRust-Oleum ManualsMarking Paint266575

TECHNICAL DATA PRO-14

PROFESSIONAL

2X DISTANCE MARKING PAINT SPRAYS

Form: GDH-156

Rev.: 100115

.DESCRIPTION AND USES .

Rust-Oleum

Professional 2X Distance Marking Paint

Sprays are an aerosol coating packaged for use in an

inverted position as a marking paint. Use for marking

construction and excavation sites, underground utilities

and for traffic safety. This product is not water soluble and

withstands general weathering. These sprays are

recommended for use with Rust-Oleum

#2393000

Marking Wand and feature fast dry and adhesion to

concrete, blacktop, gravel, soil and grass.

.APPEARANCE .

Flat to semi-gloss finish (dependent on surface porosity).

.PRODUCTS .

SKU Description

266574 Fluorescent Green

266575 Caution Blue

266577 High Visibility Yellow

266579 Fluorescent Orange

266590 Fluorescent Red-Orange

266591 Safety Red

266592 Fluorescent Pink

266593 White

266594 Clear

.PACKAGING .

15-ounce containers, 6 containers/carton

..PAINTING CONDITIONS .

Use when temperature is 40-90°F (4-32°C) and humidity is

below 85% to ensure proper drying. Avoid spraying in very

windy, dusty conditions. Protect surrounding surfaces from

overspray. Overspray can carry a significant distance.

..PRODUCT APPLICATION .

SURFACE PREPARATION

Remove excessive loose debris from the surface before

application of the coating.

..PRODUCT APPLICATION .

APPLICATION

Shake can vigorously for one minute after the mixing ball begins

to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN.

Contact Rust-Oleum. Shake often during use. Hold can upright

6-8” from surface and spray in a steady back-and-forth motion,

slightly overlapping each stroke. Keep the can the same

distance from the surface. Keep the can in motion while spraying.

Apply two or more light coats a few minutes apart. Do not use

near open flame.

DRY & RECOAT

Dry and recoat times are based on 70ºF and 50% relative

humidity. Allow more time at cooler temperatures. Dries to touch

in 15 minutes and is fully dry in 8 hours.

CLEAN-UP

When finished spraying, clear spray valve by turning can upright

and pushing spray button for 2-3 seconds. Clean-up wet paint

with xylene or mineral spirits. Properly discard empty container.

Do not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a solvent

such as mineral spirits. Do not insert any object into can valve

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA PRO-14 PROFESSIONAL 2X DISTANCE MARKING PAINT SPRAYS .DESCRIPTION AND USES . ..PRODUCT APPLICATION Rust-Oleum® Professional 2X Distance Marking Paint Sprays are an aerosol coating packaged for use in an inverted position as a marking paint. Use for marking construction and excavation sites, underground utilities and for traffic safety. This product is not water soluble and withstands general weathering.
PAGE 2
TECHNICAL DATA PROFESSIONAL 2X DISTANCE MARKING PAINT SPRAYS PHYSICAL PROPERTIES . 2X DISTANCE MARKING PAINT SPRAYS Resin Type Modified Alkyd Pigment Type Varies with color Solvents Acetone, Aliphatic Hydrocarbons Fill Weight 15 ounces MIR 1.20 Max Practical Coverage at Recommended DFT (assumes 15% material loss) Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity Up to 800 linear feet (243 meters) at 1.5 in wide (3.