MSDS

265053 R-O QT KIT 2PK PATCH AND CRACK FILLER Page 2 of 5
2
Section 3 – Composition / Information on Ingredients
Chemical Name CAS
Number
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH
TLV-STEL
OSHA PEL-
TWA
OSHA PEL-
CEILING
Silica, Crystalline,
Quartz
14808-60-7 85%
0.025 mg/m
3
[Respirable
Dust]
N.E
0.1 mg/m
3
[Respirable Dust]
0.3 mg/m
3
[Total
Dust]
5 mg/m
3
[Respirable Dust]
15 mg/m
3
[Total
Dust]
Portland Cement 65997-15-1 40%
1 mg/m
3
[Respirable
Dust]
N.E. N.E.
5 mg/m
3
[Respirable Dust]
15 mg/m
3
[Total
Dust]
Fly Ash 68131-74-8 7.0%
N.E. N.E. 5 mg/m
3
[Respirable Dust]
15 mg/m
3
[Total
Dust]
N.E.
Vinyl Acetate
Copolymer
Proprietary 5.0% N.E. N.E. N.E. N.E.
Calcium Sulfate 7778-18-9 5.0%
10 mg/m
3
[Respirable
Dust]
N.E. N.E. N.E.
Section 4 – First Aid Measures
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. Avoid further overexposure. If symptoms persist, get medical
attention.
First Aid - Ingestion: Do not induce vomiting unless advised by a physician. Call nearest Poison Control Center or
Physician immediately.
Section 5 – Fire Fighting Measures
Flash Point N.A.
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: N.A. This material is not expected to ignite under normal conditions.
Special Firefighting Procedures: This material is not expected to burn.
Section 6 – Accidental Release Measures
Steps To Be Taken If Material Is Released or Spilled: Use appropriate protective equipment. Avoid contact with
material. Dampen material with water to control dusting. Scoop up and transfer to appropriate container for
disposal. Flush spill area with water.