Use and Care Manual

TECHNICAL DATA
CONCRETE SEALER
CONCRETE SEALER
Rust-Oleum Corporation Form: CS1651
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 110512
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
CONCRETE SEALER
Resin Type Acrylic Emulsion
Pigment Type NA
Solvents Water
Weight
Per Gallon 8.50 – 8.60 lbs
Per Liter 1.02 – 1.03 kg
Solids
By Weight 25.2% (Gloss) 14.4% (Matte)
By Volume 23.1% (Gloss) 12.8% (Matte)
Volatile Organic Compounds <100g/l (0.83lbs./gal.)
Practical Coverage at
Recommended DFT (assume
15% material loss)
250-400 sq.ft./gal. (6.2-9.8 m2/l) for bare smooth concrete
155-250 sq.ft./gal. (4.3-4.9 m2/l) for rough or porous surfaces
Dry Times at
70-80°F (21-
27ºC) and 50%
Relative
Humidity
Touch 1 hour
Recoat 1 hour
Shelf Life 5 years
Safety
Information
Flash Point >200ºF (93ºC)
For additional information, see MSDS.
NOTE: Calculated values may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.