Manualshelf

Technical Specifications

ManualsBrandsRust-Oleum ManualsCraft PaintPainter's Touch® Ultra Cover Oil-Rubbed Bronze Premium Metallic Paint - 1 qt.
12
TECHNICAL DATA
PTUC-11
PAINTER’S TOUCH
®
ULTRA COVER
SATIN METALLIC FINISH
1
DESCRIPTION AND USES
Rust-Oleum
®
Painter’s Touch
®
Satin Metallic Finish provides
long lasting protection and durability. This high quality
metallic goes on smoothly and provides a rich finish. It is
ideal for a variety of indoor projects.
PRODUCTS
SKU
DESCRIPTION (Quart)
254101
Oil-Rubbed Bronze
258203
Aged Copper
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE
STARTING PROJECT
APPLICATION CONDITIONS
Apply only when air and surface temperatures are above
50-90ºF (10-32ºC) and humidity is below 85% to ensure
proper drying.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with soap and water. Rinse
thoroughly with fresh water and allow to fully dry. Remove
loose paint and rust with a wire brush or sandpaper. Lightly
sand glossy surfaces.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
PRIMING
Use of Painter’s Touch
Ultra Cover Primer provides a sound
base for topcoat adhesion and is especially recommended
for bare wood and metal. Recommended primers include
2244T or 267268 White or 1980502 Flat Gray Primer.
APPLICATION
Before using, stir thoroughly to ensure any settled pigment is
re-dispersed. If thinning is necessary, thin material only with
mineral spirits or acetone. For brush or roller, thin no more
than 5%. Apply with a good quality brush, roller, or spray
gun. Avoid painting in direct sunlight or on hot surfaces.
Avoid excessive brushing as this will reduce film thickness
and protection. Use light, even strokes to ensure an even
flow and the smoothest finish.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. May
recoat when fully dry, usually in 24 hours. Dries to the touch
in 2-4 hours and to handle in 5-9 hours.
CLEAN-UP
Clean brush and other application tools with mineral spirits.

Summary of content (2 pages)