Technical Specifications
TECHNICAL DATA ATO-13
AUTOMOTIVE
LENS TINT
.DESCRIPTION AND USES .
Rust-Oleum
®
Lens Tint is a translucent coating that is designed
to
give
your vehicle
a
customized appearance. When
applied, Lens Tint
gives your lights a tinted appearance until they are lit.
When
illuminated
the
natural color shows
through.
Lens
tint is
ideal
for tail
lights, fog lights, side markers, or turn indicators.
Recommended for
off road use. Rust-Oleum
®
Lens
Tint
features an
advanced
spray
system that allows you to spray at any angle, even upside down
for
those hard to
reach areas.
A
comfort
spray tip
with
a
wider
finger pad
reduces fatigue caused by continuous
spraying.
.
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F (10°C) and
90°F (32°C) and humidity is below 85% to ensure proper
drying. Do not apply to surfaces, when heated, exceed 200°F
(93°C). Avoid spraying in very windy and dusty
conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Removing the lens from your vehicle is recommended
for ease
of application. If you cannot remove the lens
fr
om
your
vehicle,
mask adjoining areas to protect
fr
om spray
mist.
Prepare the
surface by removing any oil, grease, wax, or
road
tar. For best
results use a clean cloth and wipe the
surface
with
Rust-Oleum
®
W
ax & Tar
Remover.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady
back-and-
forth motion, slightly overlapping each stroke. Keep the can in
motion while spraying. Apply one light coat or just enough
to
change the lens color. DO NOT exceed three coats or light
may not show through. Do not use near open
flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50%
relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20 minutes, to handle in 1 hour and fully dry in 24
hours. Apply a second coat within 1 hour or after 24 hours.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene
or
mineral spirits. Properly discard empty container. Do not
burn
or place in home trash compactor.
CLOGGING
If the valve
c
logs, twist and pull off spray tip and rinse in
a
solvent such as mineral spirits. Do not insert any object
into
can valve
opening.
1