Specification Sheet

TECHNICAL DATA
ESH-09
EPOXYSHIELD
®
WATER-BASED EPOXY
GARAGE FLOOR COATING (CAN KITS)
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877·385·8155
www.rustoleum.com
Form: GDH-356
Rev.: 013018
PHYSICAL PROPERTIES
WATER-BASED EPOXY GARAGE FLOOR COATING
Resin Type
Amine Cured Epoxy
Pigment Type
Titanium Dioxide
Solvents
Ethylene Glycol Monopropyl Ether, Water
Weight
Per Gallon
10.50 – 10.60 lbs.
Per Liter
1.25 – 1.27 kg.
Solids
By Weight
62.6 – 63.3%
By Volume
52.6 – 52.8%
Volatile Organic Compounds
>50 g/l
Mixing Ration
3:1 (Base to Activator by volume)
Induction Period
Varies with temperature- See chart in directions
Pot Life @ 70-80°F (21-27°C) and 50%
Relative Humidity
Varies with temperature- See chart in directions
Recommended Dry Film
Thickness (DFT) per Coat
3.0-3.5 mils
(75-87.5µ)
Wet Film to Achieve DFT (Unthinned
material)
6.0-7.0 mils
(150-175µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
Approximately 250 sq.ft./1 car kit. (6.2 m
2
/l)
Approximately 500 sq.ft./2.5 car kit (12.4 m
2
/l)
Dry Times based on
70-80°F (21-27°C) and
50% Relative
Humidity
Foot Traffic
24 hours
Vehicle Traffic
3 days
Shelf Life
5 years
Flash Point
>200°F (93°C) Activated material
Safety Information
For additional information, see SDS
Calculated values may vary slightly from the actual manufactured material.
*Activated material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.