SDS

Date Printed: 5/15/2015
Propane 74-98-6 20.0 1000 ppm N.E. 1000 ppm N.E.
Hydrous Magnesium Silicate 14807-96-6 15.0
2 mg/m3
(Respirable Dust)
N.E.
20 mppcf (Mineral
Dust <1% Quartz)
N.E.
Acetone 67-64-1 10.0 500 ppm 750 ppm 1000 ppm N.E.
n-Butane 106-97-8 10.0 1000 ppm 1000 ppm N.E. N.E.
Xylene (mixed isomers) 1330-20-7 10.0 100 ppm 150 ppm 100 ppm N.E.
Toluene 108-88-3 10.0 20 ppm N.E. 200 ppm 300 ppm
n-Butyl Acetate 123-86-4 10.0 150 ppm 200 ppm 150 ppm N.E.
Aliphatic Hydrocarbon 64742-89-8 5.0 350 ppm N.E. 500 ppm N.E.
Mineral Spirits 64742-88-7 5.0 100 ppm N.E. 100 ppm N.E.
Titanium Dioxide 13463-67-7 5.0
10 mg/m3 (Total
Dust)
N.E.
15 mg/m3 [Total
Dust]
N.E.
Aromatic Petroleum Distillates 64742-94-5 5.0 N.E. N.E. N.E. N.E.
Titanium Dioxide 1317-80-2 5.0 10 mg/m3 N.E.
15 mg/m3 (Total
Dust)
N.E.
Ethylbenzene 100-41-4 5.0 20 ppm 125 ppm 100 ppm N.E.
Zinc Phosphate 7779-90-0 5.0 N.E. N.E. N.E. N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use explosion-proof ventilation equipment. Provide general dilution of local exhaust ventilation in
volume and pattern to keep TLV of hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors
and windows to achieve cross-ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with
organic vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to
exceed exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin
protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like
Odor Threshold:
N.E.
Relative Density:
0.855
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Slight
Partition Coefficient, n-
octanol/water:
No Information
Decompostion Temp., °C:
No Information
Boiling Range, °C:
-11 - 5432
Explosive Limits, vol%:
0.7 - 14.3
Flammability:
Does not Support Combustion
Flash Point, °C:
>94
Evaporation Rate:
Faster than Ether
Auto-ignition Temp., °C:
No Information
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Avoid temperatures above 120 ° F. Avoid contact with strong acid and strong bases. Avoid all possible
sources of ignition.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
HAZARDOUS DECOMPOSITION: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it emits
acrid smoke and irritating fumes. Contains solvents which may form carbon monoxide, carbon dioxide, and formaldehyde.
HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
STABILITY: This product is stable under normal storage conditions.
Page 4 / 8