Technical Specifications

Rust-Oleum
®
Filler Primer - Aerosol
DESCRIPTION A high-build primer for filling in minor surface imperfections.
USES Ideal for filling in minor imperfections on metal, wood and fiberglass surfaces.
APPEARANCE Available in Gray and Red
SURFACE PREPARATION (See directions on can for more details)
Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy
surfaces. Clean the surface with soap and water, rinse and let dry. Note: Cleaning is
recommended before and after wire brushing or sanding.
MIXING Shake can vigorously for one minute after mixing ball begins to rattle. Shake the can
often during use.
APPLICATION Use outdoors or in a well-ventilated area such as an open garage. Use when
temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85% to
ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or galvanized metal. Avoid spraying in very windy, dusty conditions. Cover
surrounding area to protect from spray mist. Hold the can 12-16" from surface and
spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion while spraying. Apply 2 or
more light coats a few minutes apart.
PHYSICAL PROPERTIES (Calculated values, may vary slightly from the actual manufactured material)
RESIN TYPE Alkyd
SOLVENT TYPE: Ketone/aromatic
VOC (Volatile Organic Compounds) NA
WEIGHT PER GALLON NA
WEIGHT PER LITER NA