Technical Specifications

TECHNICAL DATA

PAINTER’S TOUCH ULTRA COVER 2X PRIMER SPRAYS & BRUSH

PRODUCT APPLICATION (cont.) .

PAINTING

Aerosols - Shake can vigorously for one minute after the

mixing ball begins to rattle. If mixing ball f ails to rattle DO NOT

STRIKE CAN. Cont act Rust-Oleum. Shake often during use.

Hold can upright 10-16” from surface and spray in a steady

back-and-forth motion, slightly overlapping each stroke. Keep

the can the same distance from the surface. Keep the can in

motion while spraying. Apply two or more light coats a few

minutes apart to avoid drips and runs. Do not use near open

flame.

Brush - Before using, stir thoroughly to ensure any settled

pigment is re-dispers ed. Thinning is not

equired. In hot, dry

conditions, thin up to 2 ounces water per quart t o extend dry

time. Avoid painting in direct sunlight or on hot surfaces. Use

a good quality synthetic brush. Avoid excessive brushing as

this will reduce film thickness and protection. Use light even

strokes to ensure smooth and uniform flow.

DRY & RECOAT TIMES

Dry and recoat times are based on 70ºF (21ºC) and 50%

relative humidity. Allow more time at cooler temperatures.

Aerosols - Dries to the touch in 20 minutes and handle in 1

hour. May recoat within 1 hour or after 24 hours. Brush –

Dries to touch in 30-60 minutes and handle in 1-2 hours. May

recoat in 2-4 hours.

CLEAN-UP

Aer osols -

ipe off tip before storing. Clean-up wet paint with

xylene or mineral spirits. Pr operly discard empty container.

Do not burn or place aerosols in home tr ash compactor.

Brush – Clean brush and other application tools with soap

and water.

CLOGGING

If the valve c logs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object into

can valve opening.