Technical Specifications
TECHNICAL DATA PTX-01
DESC
DESCRIPTION AND USES
Rust-Oleum® Painter’s Touch® Ultra Cover 2X Enamel Sprays are designed to provide long lasting protection and durability. These sprays apply easily,
provide excellent coverage and dry fast to a tough attractive finish. Rust-Oleum® Painter’s Touch® Ultra Cover 2X Enamel Sprays feature and
advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger
pad to reduce fatigue caused by continuous spraying. Not f or use on galvanized metal.
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50ºF (10ºC) and 90ºF (32ºC) and humidity is
below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Do not apply to galvanized steel. Avoid spraying in
very windy and dusty conditions. Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method.
Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces to create a
surface profile. W ARNING! If you scrape, sand or remove old paint from any surface, you may release lead paint dust. LEAD IS TOXIC. EXPOSURE
TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO
AVOID EXPOSURE. W ear a NIOSH approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
PRIMING
Use of a Painter’s Touch® primer provides excellent adhesion and hiding and is especially recommended for bare wood and metal. The following primers
are recommended.
249086 Red Primer
249088 Gray Primer
249846 Black Primer
249058 White Primer
PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum.
Shake often during use. Hold can upright 10-16” from surface and spray in a steady back-and- forth motion, slightly overlapping each stroke. Keep the
can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and
runs. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 20 minutes, to handle in 1
hour, and fully dry in 24 hours. Apply a second coat or Clear coat within 1 hour or after 24 hours. Apply Clear c oat in 2-3 light coats a few minutes
apart.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash
compactor.
CLOGGING
If the valve c logs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.
Physical Properties
Finishes
Resin Type
Acrylic Modified Alkyd
Pigment Type
Varies with color
MIR
1.5 Max
Fill Weight
12 ounces