Technical Specifications

Rust-Oleum

Engine Enamel - Aerosol

DESCRIPTION A protective enamel suitable for surfaces that reach temperatures up to 500° F.

USES For use on automotive engines and automotive surfaces which reach intermittent

temperatures of 500°F (260° C).

APPEARANCE Available in Gloss, Semi-Gloss, Clear and Flat sheens.

PACKAGING Cast Coat Aluminum, Cast Coat Iron and Clear are available in an 11 oz. aerosol spray

can. All other colors are available in a 12 oz aerosol spray can. All aerosol spray cans

feature an Any-Angle Spray system that lets you cover hard to reach places, even if the

can is sprayed upside-down and also features a Comfort Tip spray nozzle to eliminate

finger fatigue.

SURFACE PREPARATION (See directions on can for more details)

Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy

surfaces. Clean the surface with soap and water, rinse and let dry. The use of

Rust-Oleum

Engine Primer will provide additional adhesion and hiding and is

especially recommended for bare metal.

MIXING Shake can vigorously for one minute after mixing ball begins to rattle. Shake the can

often during use.

APPLICATION Use outdoors or in a well-ventilated area such as an open garage. Use when

temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85% to

ensure proper drying. Avoid spraying in very windy, dusty conditions. Cover the

surrounding area to protect from spray mist. Hold the can 10-16" from surface and

spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can

the same distance from the surface. Keep the can in motion while spraying. Apply 2 or

more light coats a few minutes apart.

PAGE 1
Rust-Oleum® Engine Enamel - Aerosol DESCRIPTION A protective enamel suitable for surfaces that reach temperatures up to 500° F. USES For use on automotive engines and automotive surfaces which reach intermittent temperatures of 500°F (260° C). APPEARANCE Available in Gloss, Semi-Gloss, Clear and Flat sheens. PACKAGING Cast Coat Aluminum, Cast Coat Iron and Clear are available in an 11 oz. aerosol spray can. All other colors are available in a 12 oz aerosol spray can.
PAGE 2
PHYSICAL PROPERTIES (Calculated values, may vary slightly from the actual manufactured material) RESIN TYPE Modified alkyd SOLVENT TYPE: Ketone/aromatic VOC (Volatile Organic Compounds) NA WEIGHT PER GALLON NA WEIGHT PER LITER NA SOLIDS BY WEIGHT 13.7 – 27.4% SOLIDS BY VOLUME NA RECOMMENDED DRY FILM THICKNESS PER COAT WET FILM TO ACHIEVE DFT 1.0 mil 3.