Technical Specifications

TECHNICAL DATA ATO-12
AUTOMOTIVE
PAINT FOR PLASTIC
.DESCRIPTION AND USES .
Rust-Oleum
®
Paint for Plastic renews and revitalizes indoor and
outdoor plastics. No primer is required. These sprays are ideal for
use on automotive plastics, polypropylene, polystyrene resin, PVC,
and fiberglass. Test this product in an inconspicuous area to test for
compatibility on the surface. Rust-Oleum
®
Paint for Plastic features
an advanced spray system that allows you to spray at any angle,
even upside down for those hard to reach areas. A comfort spray tip
with a wider finger pad reduces fatigue caused by continuous
spraying.
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F (10°C) and
90°F (32°C) and humidity is below 85% to ensure proper
drying. Do not apply to surfaces, when heated, exceed 200°F
(93°C). Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
For new plastic surfaces, thoroughly wipe down surface with
paint thinner t o promote adhesion. For aged or weathered
surfaces, remove loose material with a brush or scr aper,
clean with soap and water, rinse and let dry. Sanding may be
required for glossy or smooth surfaces. If mildew is present,
wash with a bleach solution, rinse and let dry.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-12" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can in
motion while spraying. Apply 2 or more light coats a few
minutes apart. Maximum adhesion is achieved in 5-7 days.
Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20-30 minutes, to handle in 1 hour and fully dry in 24
hours. Apply a second coat within 1 hour or after 48 hours.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in home trash compactor.
CLOGGING
If the valve c logs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.
1