Technical Specifications

UNIVERSAL GLOSS SPRAY PAINT
DESCRIPTION Versatile all-surface paint that provides the ultimate in long-lasting protection and
durability. Delivers exceptional coverage on plastic, wood, metal, concrete, wicker,
aluminum and masonry surfaces. Features an advanced spray system that allows you
to spray at any angle, even upside down for those hard to reach areas. A comfort grip
trigger eliminates finger fatigue caused by continuous spraying.
USES Ideal for use on indoor and outdoor wood, metal, wicker, plastic and more.
APPEARANCE High gloss, satin, flat finishes
SURFACE PREPARATION Remove loose paint and rust with wire brush or sandpaper. Lightly sand glossy
surfaces. Clean with soap and water, rinse and let dry. For superior adhesion and
hiding and for bare wood or metal, first prime with a Universal Primer.
APPLICATION Use outdoors or in a well-ventilated area such as an open garage. Spraying can
produce a fog that will travel. Protect surrounding area, clothing and skin from over-
spray. Shake can vigorously for 1 minute after mixing ball begins to rattle. Prior to
use, slide off the red safety clip from the trigger. Shake often during use. Hold can
upright 8-12” from surface and spray in a steady back and forth motion, slightly over-
lapping each stroke. Keep the can the same distance from the surface. Keep the can
in motion while spraying. Apply 2 or more medium coats applied at moderate speed.
CLEAN UP When finished spraying, wipe off tip before storing. Clean up wet paint with Xylol or
mineral spirits. Dispose of empty can in recycle pick-up. Do not burn or place in home
trash compactor.
PHYSICAL PROPERTIES (Calculated values, may vary slightly from the actual manufactured material)
RESIN TYPE Chain stopped alkyd
SOLVENT TYPE: Aromatic/Ketone blend
VOC (Volatile Organic Compo unds)* High gloss and satin: Max VOC 65%, Max MIR 1.40
Flat: Max VOC 60%, Max MIR 1.20
PRACTICAL COVERAGE Up to 25 square feet per can
APPLICATION CONDITIONS Apply between 50 and 90 degrees F, below 85% humidity
DRY TIMES @70° - 80°F (21° - 27° C) AND 50%RH Touch 1 hour
Handle 4 hours
Recoat Within 1 hour or after 48 hours.
SHELF LIFE 5 Years
SAFETY (For additional information, see MSDS)
FLASHPOINT -156 F (-144 C)
LEAD-FREE